Mitsubishi Lancer Evolution Wiper Blades Size Guide

The Mitsubishi Lancer Evolution is a high performance sedan derived from the standard Lancer, built by Mitsubishi as a rally bred performance variant with turbocharged all wheel drive. Across the model range the Lancer Evolution most commonly takes a 24 inch (600mm) blade on the driver side and an 18 inch (450mm) blade on the passenger side, although sizes vary by generation as shown below. Front wipers use a J-Hook connector throughout the range, and most generations are fitted with a rear wiper, with the exception of the final X series which uses front wipers only. Find your vehicle year in the table below.

Frequently Asked Questions

What size wiper blades does a Mitsubishi Lancer Evolution take?

Wiper blade sizes for the Lancer Evolution vary by generation. The I, II and III series and the IV, V and VI series use a 20 inch (500mm) driver blade and a 17 inch (425mm) passenger blade, the VII, VIII and IX series steps up to a 24 inch (600mm) driver blade and an 18 inch (450mm) passenger blade, and the X series uses a 24 inch (600mm) driver blade with a 17 inch (425mm) passenger blade. Checking the table above against the build year confirms the correct size.

Does the Mitsubishi Lancer Evolution have a rear wiper?

Most Lancer Evolution generations are fitted with a rear wiper blade. The I, II and III series uses an 18 inch (450mm) rear blade, the IV, V and VI series uses a 16 inch (400mm) rear blade, and the VII, VIII and IX series uses a 17 inch (425mm) rear blade. The X series is the exception and is fitted with two front wiper blades only, which can be confirmed in the specifications on the product page.

What wiper connector does the Mitsubishi Lancer Evolution use?

The Mitsubishi Lancer Evolution uses a J-Hook adaptor on the front wiper arms across every generation. This connector type has remained consistent from the I series through to the X series, simplifying replacement regardless of model year.

Does the Lancer Evolution use the same wiper blades as the standard Lancer?

No, the Lancer Evolution requires different wiper blade sizes to the standard Lancer in most generations, due to its unique bonnet and cowl design alongside model specific wiper arm geometry. Owners should always select blades listed specifically for the Lancer Evolution rather than the standard Lancer range to ensure a correct fit.

How often should I replace Mitsubishi Lancer Evolution wiper blades?

Wiper blades on the Lancer Evolution typically need replacing around every 12 months under normal Australian conditions. Heat, UV exposure and road grit can wear down the rubber faster, so a yearly check before the wetter months helps maintain clear visibility.

Browse all Mitsubishi Lancer Evolution wiper blades, return to the Mitsubishi wiper blades page, or visit our wiper blades size guide for all makes and models.